Agilent Technologies U9072A cdma-2000

1251

Source (Internal)

Step Configuration of Radio Band parameter list (Remote Command Only)

This SCPI command is to configure “Radio Band” parameter array of the whole List Sequencer at one time. The

number of array is same as step number defined in “Number of Steps” on page 1221 Number of Steps. As a step is

setup, the value entered run through several levels of validation.

Step Configuration of Radio Band Link parameter list (Remote Command Only)

This SCPI command is to configure “Radio Band Link” parameter array of the whole List Sequencer at one time.

The number of array is same as step number defined in “Number of Steps” on page 1221 Number of Steps. As a

Notes: The command is to setup below parameter array of whole list sequence.

Transition Time <time> - specifies the transition time for the stepin seconds.

For details of the valid ranges for the transition time see “Transition Time” on

page 1224

If input parameter number exceeds the step number defined by Number of

Steps then generate error ", and only those parametes whose index number

falls in number of steps will be updated.

Dependencies: The range is 1 to 1000 which is determined by the number of steps you have

configured. For details see “Number of Steps” on page 1221.

Initial S/W Revision: A.09.40

Remote Command: :SOURce:LIST:SETup:RADio:BAND <enum>, <enum>, <enum>, …

:SOURce:LIST:SETup:RADio:BAND?

Example: SOUR:LIST:SET:RAD:BAND PGSM, EGSM, RGSM

SOUR:LIST:SET:RAD:BAND?