1247
Source (Internal)
selected for playback during this step. For example, a 5 second ARB will be set to play 5 times during the step.
Play Count
Allows you to specify the number of times the current ARB waveform file will play during a step.
Continuous
Sets the current step to be played continuously until the next step starts.
Key Path: Source, List Sequencer, List Sequencer Setup, Step Duration
Example: SOUR:LIST:STEP2:SET:DUR:TYPE COUN
Notes: SCPI is supported after A.09.40 This key is unavailable and is grayed out if
the current step is configured to CW tone rather than an ARB waveform.
Initial S/W Revision: A.05.00
Key Path: Source, List Sequencer, List Sequencer Setup, Step Duration, Time, Play
Count
Remote Command: :SOURce:LIST:STEP[1]|2|3…1000:SETup:DURation:TCOunt
<double>
:SOURce:LIST:STEP[1]|2|3…1000:SETup:DURation:TCOunt?
Example: SOUR:LIST:STEP2:SET:DUR:TCO 10
SOUR:LIST:STEP2:SET:DUR:TCO?
Notes: SCPI is supported after A.09.40
This SCPI is reused by “Play Count” and “Duration Time” according to
current Duration Type setting if “Play Count” or “Duraton Time”.
If current “Duration Type” is “Continuous”, then popup error –221,"Settings
conflict;Cannot accept time or count input when step duration type is
Continuous on step #"
Notes: If “Play Count” is set for the last step, the last step of ARB keeps playing as if
set to “Continuous” after play count setting is reached.
Preset: 1
Min: 1
Max: 65536
Initial S/W Revision: A.05.00
Key Path: Source, List Sequencer, List Sequencer Setup, Step Duration
Example: SOUR:LIST:STEP2:SET:DUR:TYPE CONT
Notes: SCPI is supported after A.09.40
Initial S/W Revision: A.05.00