977
Input/Output
Amplitude
Lets you edit the Amplitude of the current row.
Insert Point Below
Inserts a point below the current point. The new point is a copy of the current point and becomes the current point.
The new point is not yet entered into the underlying table, and the data in the row is displayed in light gray.
Delete Point
Deletes the currently-selected point, whether or not that point is being edited, and selects the Navigate
functionality. The point following the currently-selected point (or the point preceding if there is none) will be
selected.
Scale X Axis
Matches the X Axis to the selected Correction, as well as possible. Sets the Start and Stop Frequency to contain the
minimum and maximum Frequency of the selected Correction. The range between Start Frequency and Stop
Frequency is 12.5% above the range between the minimum and maximum Frequency, so that span exceeds this
range by one graticule division on either side. If in zero-span, or there is no data in the Ampcor table, or the
frequency range represented by the table is zero, no action is taken. Standard clipping rules apply if the value in the
table is outside the allowable range for the X axis.
Initial S/W Revision: A.10.00
Key Path: Input/Output, RF Output & Test Set Config, Multiport Adapter,
Corrections, Edit
Notes: There is no value readback on the key.
Min: –1000 dB
Max: 1000 dB
Initial S/W Revision: A.10.00
Key Path: Input/Output, RF Output & Test Set Config, Multiport Adapter,
Corrections, Edit
Initial S/W Revision: A.10.00
Key Path: Input/Output, RF Output & Test Set Config, Multiport Adapter,
Corrections, Edit
Initial S/W Revision: A.10.00
Key Path: Input/Output, RF Output & Test Set Config, Multiport Adapter,
Corrections, Edit
Dependencies: If either the first or last point in the array is outside the frequency range of the
current input, an error message is generated:
“–221. Settings conflict; Start or Stop Freq out of range for current input
settings”