275
System Functions
System
Every N Weeks
Enables you to configure the scheduler to run the task on a day in every number of week’s duration.
N of Weeks
Enables you to set the number of weeks that the scheduler will wait to trigger a task.
Day
Enables you to set the Day of the Week the scheduler will run a scheduled task.
Range: DAY|WEEK |OFF
Initial S/W Revision: A.08.00
Key Path: System, Alignments, RF Preselector, Schedule Setup, Recurrence
Initial S/W Revision: A.08.00
Key Path: System, Alignments, RF Preselector, Schedule Setup, Recurrence, Every
N Weeks
Mode: All
Remote Command: :CALibration:RFPSelector:SCHeduler:RECurrence:WEEK
<integer>
:CALibration:RFPSelector:SCHeduler:RECurrence:WEEK?
Example: :CAL:RFPS:SCH:REC:WEEK 2
Notes: New scheduled date to run the alignment task will get updated when this
parameter is changed. For model N9038A only.
Preset: This is unaffected by Preset but is set to 1 on a “Restore System
Defaults->Align”.
State Saved: No
Range: 1–52
Initial S/W Revision: A.08.00
Key Path: System, Alignments, RF Preselector, Schedule Setup, Recurrence, Every
N Weeks
Mode: All
Remote Command: :CALibration:RFPSelector:SCHeduler:RECurrence:DAY
SUN|MON|TUE|WED|THU|FRI|SAT
:CALibration:RFPSelector:SCHeduler:RECurrence:DAY?
Example: :CAL:RFPS:SCH:REC:DAY SUN
Notes: For model N9038A only.