1256
Source (Internal)
Step Configuration of Output Trigger parameter list (Remote Command Only)
This SCPI command is to configure “Output Trigger”parameter array of the whole List Sequencer at one time. The
number of array is same as step number defined in “Number of Steps” on page 1221 Number of Steps. As a step is
setup, the value entered run through several levels of validation.
Clear List (Remote Command Only)
This command is the SCPI equivalent of the Clear List UI featuredescribed in.
Multiport Adapter Output Port Bitmap Mode
When this setting is set to LIST, it will allow you to select the multiport adapter output path of each step.
When this setting is set to FIXed, source list sequence multiport adapter output path on each step is
controlled by global multiport adapter output port bitmap setting (same as source independent mode).
Under this situation, source list sequence will ignore local multiport adapter output port bitmap setting
defined in each step, they are still there and can be queried out, but take no effect.
Remote Command: :SOURce:LIST:SETup:OUTPut:TRIGger <bool>, <bool>,
<bool>, …
:SOURce:LIST:SETup:OUTPut:TRIGger ?
Example: SOUR:LIST:SET:OUTP:TRIG ON,OFF,ON
SOUR:LIST:SET:OUTP:TRIG?
Notes: The command is to setup below parameter array of whole list sequence.
Output Trigger <Boolean> - specifies the output trigger for the step. For
details of the ranges for this setting see “Output Trigger” on page 1248.
If input parameter number exceeds the step number defined by Number of
Steps then generate error ", and only those parametes whose index number
falls in legal step number will be updated.
Remote Command Notes: ON|OFF|1|0
Dependencies: The range is 1 to 1000 which is determined by the number of steps you have
configured. For details see “Number of Steps” on page 1221.
Initial S/W Revision: A.09.40
Remote Command: :SOURce:LIST:SETup:CLEar
Example: SOUR:LIST:SETup:CLE
Initial S/W Revision: A.05.00
Key Path: Source, List Sequencer
Remote Command: :SOURce:LIST:MPADapter:PORT:OUTPut:BITMap:MODE LIST |
FIXed
:SOURce:LIST:MPADapter:PORT:OUTPut:BITMap:MODE?