Agilent Technologies U9072A cdma-2000 See More Information on page 1271.

1270

Sweep/Control

Sweep Time RulesAllows the choice of three distinct sets of sweep time rules. These are the rules that are used to set the sweep time when Sweep Time is in Auto mode. Note that these rules only apply when in the Swept

Sweep Type (either manually or automatically chosen) and not when in FFT sweeps.

See “More Information” on page 1271.

Key Path: Sweep/Control, Sweep Setup

Remote Command: [:SENSe]:SWEep:TIME:AUTO:RULes

NORMal|ACCuracy|SRESponse

[:SENSe]:SWEep:TIME:AUTO:RULes?

Example: SWE:TIME:AUTO:RUL ACC

Dependencies: In Zero Span, this key is irrelevant and cannot be accessed (because the whole

Sweep Setup menu is grayed out in Zero Span), however its settings can be

changed remotely with no error indication.

Grayed out in FFT sweeps. Pressing the key while the instrument is in FFT

sweep generates an advisory message. The SCPI is acted upon if sent, but has

no effect other than to change the readout on the key, as long as the analyzer is

in an FFT sweep.

Couplings: Set to Auto on Auto Couple

Preset: AUTO

State Saved: Saved in instrument state

Backwards Compatibility SCPI: :SWEep:TIME:AUTO:MODE SRESponse

This legacy command is aliased to :SWEep:TIME:AUTO:RULes

SRESponse

Backwards Compatibility SCPI: :SWEep:TIME:AUTO:MODE SANalyzer

This legacy command is aliased to :SWEep:TIME:AUTO:RULes NORMal

Backwards Compatibility SCPI: :SWEep:TIME:AUTO:MODE?

This legacy query is aliased to :SWEep:TIME:RULes?, so it will match for

SRESponse but not for SANalyzer

Backwards Compatibility Notes: The old Auto Sweep Time command was the same

[:SENSe]:SWEep:TIME:AUTO:RULes NORMal|ACCuracy

so it still works although it now has a third parameter (SRESponse).

The old Sweep Coupling command was

[:SENSe]:SWEep:TIME:AUTO:MODE SRESponse|SANalyzer and it is

aliased as below:

Initial S/W Revision: Prior to A.02.00