955
Input/Output
ON/OFF. See the table below for bitmapping.Multiport Adapter Output Port Bit
RFIO0 0
RFIO1 1
RFIO2 2
RFIO3 3
RFIO4 4
RFIO5 5
RFIO6 6
RFIO7 7
Key Path: Input/Output, RF Output & Test Set Config, Multiport Adapter
Remote Command: [:SENSe]:MPADapter:PORT:OUTPut:BITMap <integer>
[:SENSe]:MPADapter:PORT:OUTPut:BITMap?
Example: :MPAD:PORT:OUTPut:BITMap 1
Notes: Each bit is associated with a multiport adapter output port; as shown in the
bitmap table above. The value of a bit is ‘0’ if the corresponding multiport
adapter output port is not selected, and ‘1’ if it is. (For example, to select
multiport adapter RFIO7 output port , set Bit 7 to ‘1’.)
The field requires a decimal entry. For example, if multiport adapter selects
the RFIO 7 output port and RFIO 0 output port, the Bit Mask for this
combination is 10000001, and the value of this parameter is the decimal
number ‘129’.
Dependencies: This menu selection does not have any effect unless Input/Output, RF Output
& Test Set Config, Multiport Adapter, Multiport Adapter is set to the On state
and Input/Output, RF Output & Test Set Config, RF Output is RF Output port.
When Input/Output, RF Output & Test Set Config, Multiport Adapter,
Multiport Adapter is set to the On state and Input/Output, RF Output & Test
Set Config, RF Output is set to RFIO1 or RFIO2 port, the Multiport Adapter
GPS Output Port will be used.
Preset: This is unaffected by Mode Preset but is set to “1” on a "Restore Input/Output
Defaults" or "Restore System Defaults -> All"
State Saved: Saved in State
Backwards Compatibility SCPI
Notes: The commands above are included for ESU compatibility
Initial S/W Revision: A.10.00