1390
Trigge r
Trig Holdoff Sets the holdoff time between triggers. When the trigger condition is satisfied, the trigger occurs, the delay begins, and the holdoff time begins. New trigger conditions will be ignored until the holdoff time expires. For a free-running trigger, the holdoff value is the minimum time between triggers.Holdoff TypeLets you set the Trigger Holdoff Type.
Notes: The "time that the analyzer will wait" starts when the analyzer is ready for a
trigger, which may be hundreds of ms after the data acquisition for a sweep is
done. The "time" ends when the trigger condition is satisfied, not when the
delay ends.
Preset: Off, 100 ms
State Saved: Saved in instrument state
Min: 1 ms
Max: 100 s
Default Unit: s
Initial S/W Revision: Prior to A.02.00
Key Path: Trigger, Auto/Holdoff
Remote Command: :TRIGger[:SEQuence]:HOLDoff <time>
:TRIGger[:SEQuence]:HOLDoff?
:TRIGger[:SEQuence]:HOLDoff:STATe OFF|ON|0|1
:TRIGger[:SEQuence]:HOLDoff:STATe?
Example: TRIG:HOLD:STAT ON
TRIG:HOLD 100 ms
Dependencies: Unavailable if the selected Input is BBIQ. If this is the case, the key is grayed
out if it is pressed the informational message “Feature not supported for this
Input” is displayed. If the SCPI command is sent, the error “Settings conflict;
Feature not supported for this Input” is generated.
Preset: Off, 100 ms
State Saved: Saved in instrument state
Min: 0 s
Max: 0.5 s
Default Unit: s
Initial S/W Revision: Prior to A.02.00