1257
Source (Internal)
Multiport Adapter Output Port Amplitude Correction Configuration Validation for List
Sequencer (Remote Command Only)
This command is used to validate MPA TX port amplitude correction for Source List Sequencer.
Manual Trigger Now
Pressing this key provides a software trigger event to the list sequencer. During execution of sequence, if
the sequencer is halted on any step that has been configured with a “Manual” step trigger, then this key
press will cause the sequencer to continue and execute the step.
Example: SOUR:LIST:MPAD:PORT:OUTP:BITM:MODE LIST
SOUR:LIST:MPAD:PORT:OUTP:BITM:MODE?
Preset: FIXed
Range: LIST | FIXed
State Saved: Yes
Initial S/W Revision: A.09.40
Key Path: Source, List Sequencer
Remote Command: :SOURce:LIST:MPADapter:CORRection:ERRor?
Example: SOUR:LIST:MPAD:CORR:ERR?
Notes: Query Only SCPI
Remote command only
If detected invalid configuration, popup error message:
"-221 Settings conflict; Source List Step<n> MPA TX port<n> amplitude
correction value <n>dB is out of range. The valid range is <n> ~ <n>dB"
Or
"-221 Settings conflict; Source List Step<n> MPA TX port<n> amplitude
correction delta exceeds <n>dB between port<n> and port<n>"
to report the first detected conflict.
Range: "No error" | Error info of the first found conflict
State Saved: Yes
Initial S/W Revision: A.12.00
Key Path: Source, List Sequencer
Remote Command: No remote command, front panel only.
Initial S/W Revision: A.05.00