372
Channel Power Measurement
View/Display
Power Results:
The spectrum trace and power bars are displayed in the upper window. Total carrier power, total PSD and
total format carrier power are displayed in the lower window. Total format carrier power is total power of
carriers of the same Radio Format. If there is no carrier of the corresponding format, it is not displayed.
Thus items in the total format power table changes depending on the carrier configuration.
Carrier Info:
The lower window of Power Results view is replaced by the carrier info table in this view. Carrier center
frequency can be displayed in either offset or absolute frequency depending on Carrier Freq. The table
can be scrolled by Carrier Result on Meas Setup menu or by Select Carrier on Config Carriers menu. The
highlighted row changes as either Carrier Result or Select Carrier is changed. The highlighted row and
these keys are not coupled.
Display
Accesses a menu of functions that enable you to set the display parameters.
See “Display” on page 1393 for more information.
Bar Graph
Turns the Bar Graph On and Off.
Key Path: Front-panel key
Initial S/W Revision: Prior to A.02.00
Key Path: View/Display
Initial S/W Revision: Prior to A.02.00
Key Path: View/Display
Mode: WCDMA, C2K, WIMAX OFDMA, 1xEVDO, LTE, LTETDD, WLAN
Remote Command: :DISPlay:CHPower:VIEW[1]:WINDow[1]:BGRaph ON|OFF|1|0
:DISPlay:CHPower:VIEW[1]:WINDow[1]:BGRaph?
Example: DISP:CHP:VIEW:WIND:BGR ON
DISP:CHP:VIEW:WIND:BGR?
Notes: You must be in the W-CDMA mode, cdma2000 mode, LTD mode, LTE TDD
mode, WLAN mode, 1xEVDO mode, or WIMAX OFDMA mode to use this
command. Use :INSTrument:SELect to set the mode.
Preset: OFF
State Saved: Saved in instrument state.
Range: On|Off
Initial S/W Revision: Prior to A.02.00