1048
Meas Setup
another set of sweeps when trigger conditions are satisfied. It only does this if an active trace is in
Average or Hold type.
Average Type
Lets you control the way averaging is done by choosing one of the following averaging scales:
log-power (video), power (RMS), or voltage averaging. Also lets you choose Auto Average Type
(default).
When performing Trace Averaging, the equation that is used to calculate the averaged trace depends on
the average type. See the descriptions for the keys which select each Average Type (“Log-Pwr Avg
(Video)” on page 1050 (Video), “Pwr Avg (RMS)” on page 1050 (RMS), or “Voltage Avg” on
page 1051) for details on these equations.
See “More Information” on page 1049.
Remote Command: [:SENSe]:AVERage:CLEar
Example: AVER:COUN 100
AVER:CLE sets the current count (k and K) to 1 and restarts the averaging
process.
Notes: When the test set receives this command it performs an INIT:IMM, if and
only if there is an active trace in Max Hold, Min Hold, or Average type.
Default Unit: Enter
Initial S/W Revision: Prior to A.02.00
Key Path Meas Setup
Remote Command [:SENSe]:AVERage:TYPE:AUTO OFF|ON|0|1
[:SENSe]:AVERage:TYPE:AUTO?
Preset ON
State Saved Saved in Instrument State
Readback line 1-of-N selection as
Log-Pwr (Video) for Log-Pwr (Video) Avg
Pwr (RMS) for Power Avg
Voltagefor Voltage
Initial S/W Revision Prior to A.02.00
Remote Command: [:SENSe]:AVERage:TYPE RMS|LOG|SCALar
[:SENSe]:AVERage:TYPE?