1177
Source (Internal)
Change Directory...
Allows you to change the currently selected directory on the hard disk. Pressing this key opens a standard windows
change directory dialog allowing you to select the new directory of interest.
The current directory is used for manually loading waveform segments into ARB memory for playback, and as a
search location for waveform segments that are required to be loaded into ARB memory for playback of a
waveform sequence or a list sequence.
Default Directory...
Allows you to change the default directory. It is used as a search location for waveform segments that are required
to be loaded into ARB memory for playback of a waveform sequence, and as a search location for selecting
waveforms using SCPI.
Notes: <string> - specifies the directory on the HDD to load the files into ARB
memory from.
When in Sequence Analyzer mode, and Include Source is Yes, an attempt to
load all files from a directory to ARB memory is rejected with an error.
When Include Source is No and there is insufficient free ARB memory to load
all the waveforms, when the ARB memory is full, the copy ceases, and an
error is generated.
If you specify a directory over SCPI, but the directory does not exist, an error
is generated.
If the ARB is ON, a user then loads or deletes file to ARB memory, the
playing waveform segment may not keep phase continuity during the ARB
memory operation. The waveform will be replayed after the ARB operation is
finished.
Initial S/W Revision: A.05.00
Key Path: Source, Modulation Setup, ARB, Select Waveform, Segments on Hard
Disk
Notes: No remote command, SCPIfront panel only.
Initial S/W Revision: A.05.00
Key Path: Source, Modulation Setup, ARB, Select Waveform, Segments on Hard
Disk
Remote Command: :SOURce:RADio:ARB:DEFault:DIRectory <string>
:SOURce:RADio:ARB: DEFault:DIRectory?
Example: SOUR:RAD:ARB:DEF:DIR “D:\ArbFiles”
SOUR:RAD:ARB:DEF:DIR?
State Saved: Persistent, survives a power cycle and a preset but not saved in the instrument
state
Initial S/W Revision: A.05.00