Agilent Technologies U9072A cdma-2000 - page 417

417
ACP Measurement
Meas Setup
[:SENSe]:ACP:OFFSet:LIST:STATe command
Turning the offset off has the same effect as setting the frequency of the offset to 0 Hz and will cause it to
be removed from the results screen.
Key Path Meas Setup, Offset/Limits
Mode WCDMA, C2K, WIMAX OFDMA, TD-SCDMA, 1xEVDO, LTE
Remote Command [:SENSe]:ACPower:OFFSet[1]|2:LIST[:FREQuency] <freq>,
<freq>, <freq>, <freq>, <freq>, <freq>
[:SENSe]:ACPower:OFFSet[1]|2:LIST[:FREQuency]?
[:SENSe]:ACPower:OFFSet[1]|2:LIST:STATe OFF|ON|0|1,
OFF|ON|0|1, OFF|ON|0|1, OFF|ON|0|1, OFF|ON|0|1,
OFF|ON|0|1
[:SENSe]:ACPower:OFFSet[1]|2:LIST:STATe?
Example ACP:OFFS1:LIST 0,0,0,0,0,0
ACP:OFFS1:LIST?
ACP:OFFS2:LIST:STAT 1,1,0,0,0,0
ACP:OFFS2:LIST:STAT?
Notes The label for this menu key will change depending on the currently selected
radio standard or mode. For cdma2000 the label for the menu key will be
Offset to Edge. For all other supported standards the label will be Offset Freq.
When setting these values remotely, the position in the list sent corresponds to
the offset. Missing values are not permitted, unless the number of values sent
is greater than the number of carriers, then subsequent values will be ignored.
Offset sub op code. 1 for BTS, 2 for MS. Default is BTS.
You must be in the mode that includes ACP measurements to use this
command. Use :INSTrument:SELect to set the mode.
Couplings Changing Offset Frequency might affect the Span. See the Span key section
for details.