ADTRAN 1000R Series

Command Reference Guide Tunnel Configuration Command Set

dial-backup restore-delay <seconds>

Use the dial-backup restore-delay command to configure the amount of time the router will wait after the

network is restored before disconnecting the backup link and reverting to the primary. This setting is used

to prevent disconnecting the backup link if the primary link is “bouncing” in and out of alarm. For more

detailed information on PPP dial-backup functionality, refer to the Functional Notes and Technology

Review sections of the command dial-backup call-mode [answer | answer-always | originate |

originate-answer | originate-answer-always] on page 1119.

Syntax Description

<seconds> S pecifies the number of seconds the AOS will wait (after a primary link is restored)

before disconnecting dial-backup operation. Range: 10 to 86,400.

Default Values

By default, dial-backup restore-delay is set to 10 seconds.

Applicable Platforms

This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.

Command History

Release 1.1 Command was introduced.

Release 5.1 Command was expanded to include the PPP interface.

Usage Examples

The following example configu res the AOS to wait 30 second s before disco nnecting dia l-backu p operation

and restoring the pr imary connection for this endpoint:

(config)#interface ppp 1

(config-ppp 1)#dial-backup restore-delay 30