ADTRAN 1000R Series

Command Reference Guide T1 Interface Configuration Command Set

remote-loopback

Use the remote-loopback command to configure the interface to respond to loopbacks initiated by a

remote unit (or the service provider). Use the no form of this command to disable this feature.

Syntax Description

No subcommands.

Default Values

By default, all interfaces respond to remote loopbacks.

Applicable Platforms

This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.

Command History

Release 1.1 Command was introduced.

Usage Examples

The following example enables remote loopbacks on the T1 interface:

(config)#interface t1 1/1

(config-t1 1/1)#remote-loopback