ADTRAN 1000R Series debug gvrp bpdus

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 110
debug gvrp bpdus
Use the debug gvrp bpdus command to see debug messages showing all GARP VLAN Registration
Protocol (GVRP) configuration messages sent and received on the switch. Debug messa ges are displayed
(real time) on the terminal (or Telnet) screen. Use the no form of this command to disable the debug
messages.
Syntax Description
No subcommands.
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 8.1 Command was introduced.
Functional Notes
With GVRP enabled on many ports, this command can produce a lot of output. To see these messages
just for individual interfaces, refer to the command debug gvrp interface <interface> [bpdus | vlans] on
page 111.
Usage Examples
The following example displays debug messages showing GVRP configuration messages sent and
received on Ethernet interface 0/24:
>enable
#debug gvrp bpdus
2000.07.31 23:15:51 GVRP BPDUS.eth 0/24: TX = (Len:2 LeaveAll) (Len:4 JoinIn Vlan:1) (End) ... SENT
2000.07.31 23 :1 5: 52 GVRP BPDUS.eth 0/24: RX = (Len:4 Empty Vlan:2) (Len:4 JoinIn Vlan:20) (end)
2000.07.31 23:15:52 GVRP BPDUS.eth 0/24: TX = (Len:4 JoinIn Vlan:1) (End) ... SENT
2000.07.31 23 :1 5: 52 GVRP BPDUS.eth 0/24: RX = (Len:4 JoinIn Vlan:20) (end)
2000.07.31 23:16:00 GVRP BPDUS.eth 0/24: RX = (Len:2 LeaveAll) (end)
#