ADTRAN 1000R Series dial-backup number , <digits> , [analog | digital-56k

Command Reference Guide ATM Sub-Interfa c e Config Command Set

dial-backup number

Use the dial-backup number command to configure the phone number and the call type the router will

dial upon network failure. Multiple entries can be made for a sub-interface to allow alternate sites to be

dialed. Fo r more detailed in formation on ATM dial-backup functionality, refer to the Functional Notes and

Technology Re view sections of the command dial-backup call-mode [answer | answer-always | originate |

originate-answer | originate-answer-always] on page 729.

Syntax Description

<digits> Specifies the phone numbers to call when the backup is initiated.

analog pp p Specifies number connects to an analog modem.

digital-56k Specifies number belongs to a digit al 56 kbps per DS0 connection.

digital-64k Specifies number belongs to a digit al 64 kbps per DS0 connection.

<isdn min chan> Specifies the minim u m nu m be r of DS0s re qu ire d for a dig ital 56 or 64 kbps

connection (R an ge: 1 to 24).

<isdn mas chan> Specifies the maximum number of DS0s desired for a digital 56 or 64 kbps

connection (R an ge: 1 to 24).

Specifies the ATM sub-interface (e.g., ATM 3.1) to use when originating or answering

using this number.

Default Va lues

By default, there are no configured dial-backup numbers.

Applicable Platforms

This command applies to the NetVanta 1000R, 3000, and 4000 Series units.

Command History

Release 1.1 Command was introduced.

Release 8.1 ATM sub-interface was added.

Usage Examples

The following example configu res the AOS to dial 704-555-1212 (digital 64 kbps connection) to initiate

dial-backup operation on this endpoint:

(config)#interface atm 1.1

(config-atm 1.1)#dial-backup number 7045551212 digital-64k 1 1 atm 3.1