ADTRAN 1000R Series

Command Reference Guide ATM Sub-Interfa c e Config Command Set

bandwidth <value>

Use the bandwidth command to provide the bandwidth value of an interface to the higher-level protocols.

This value is used in cost calculations. Use the no form of this command to restore the default values.

Syntax Description

<value> Specifies bandwidth in kbps.

Default Values

To view default values use the show interfaces command.

Applicable Platforms

This command applies to the NetVanta 300, 1000R, 3000, and 4000 Series units.

Command History

Release 3.1 Command was introduced.

Release 8.1 ATM sub-interface was added.

Functional Notes

The bandwidth command is an informational value that is communicated to the higher-level protocols to

be used in cost calculations. This is a routing parameter only and does not affect the physical interface.

Usage Examples

The following example sets bandwidth of the ATM sub-interface to 10 Mbps:

(config)#interface atm 1.1

(config-atm 1.1)#bandwidth 10000