ADTRAN 1000R Series - page 987

Command Reference Guide Loopback Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 987
bandwidth <value>
Use the bandwidth command to provide the bandwidth value of an interface to the higher-level protocols.
This value is used in cost calculations. Use the no form of this command to restore the default values.
Syntax Description
<value> Specifies bandwid th in kbps.
Default Values
To view default values, use the show interfaces command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 3.1 Command was introduced.
Functional Notes
The bandwidth command is an informational value that is communicated to the higher-level protocols to
be used in cost calculations. This is a routing parameter only and does not affect the physical interface.
Usage Examples
The following example sets bandwidth of the loopba ck interface to 10 Mbps:
(config)#interface loopback 1
(config-loop 1)#bandwidth 10000