ADTRAN 1000R Series network <ip address> <wildcard> area <area id>

Command Reference Guide Router (OSPF) Configuration Command Set

network <ip address> <wildcard> area <area id>

Use the network area command to enable routing on an IP stack and to define area IDs for the interfaces

on which OSPF will run. Use the no form of this command to disable OSPF routing for interfaces defined

using this command.

Syntax Description

<ip address> Specifies the network address <A.B.C.D>.

<wildcard> The wildcard mask is in an IP-address-type format and includes “don’t care” bits.

<area id> Specifies an identifier for this area. Specifies as an integer (range: 0 to

4,294,967,295) or an IP address <A.B.C.D>.

Default Values

No default values required for this command.

Applicable Platforms

This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900

Series units.

Command History

Release 3.1 Command was introduced.

Technology Review

In order for OSPF to operate on an interface, the

primary

address for the interface must be included in the

network area command. Assigning an interface to an OSPF area is done using the network area

command. There is no limit to the number of network area commands used on a router. If the address

ranges defined for different areas overlap, the first area in the network area command list is used and all

other overlapping portions are disregarded. Try to avoid overlapping to avoid complications.

Usage Examples

In the following example, the OSPF routing process is enabled and two OSPF areas are defined:

(config)#router ospf

(config-ospf)#network 192.22.72.101 0.0.0.255 area 0

(config-ospf)#network 10.0.0.0 0.255.255.255 area 10.0.0.0