ADTRAN 1000R Series enable

Command Reference Guide Basic Mode Command Set

enable

Use the enable command (at the Basic Command mode prompt) to enter the Enable Command mode. Use

the disable command to exit the Enable Comman d mode. Refer to Enab le Mode Command Set on page 36

for more information.

Syntax Description

No subcommands.

Default Values

No default value necessary for this command.

Applicable Platforms

This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and

Total Access 900 Series units.

Command History

Release 1.1 Command was introduced.

Functional Notes

The Enable Command mode provides access to operating and configuration parameters and should be

password protected to prevent unauthorized use. Use the enable password command (found in the

Global Configuration mode) to specify an Enable Command mode password. If the password is set,

access to the Enable Commands (and all other “privileged” commands) is only granted when the correct

password is entered. Refer to enable password [md5] <password> on page 380 for more information.

Usage Examples

The following example enters the Enab le Command mode and defines an Enable Command mode

password:

>enable

#configure terminal

(config)#enable password ADTRAN

At the next login, the following sequence must occur:

>enable

Password: ******