ADTRAN 1000R Series respond [main | aggressive

Command Reference Guide IKE Policy Command Set

respond [main | aggressive | anymode]

Use the respond command to allow the IKE policy to respond to negotiations by a peer. Use the no form

of this command to allow the policy to only initiate negotiations.

Syntax Description

main Specifies to respond only to main mode.

aggressive Specifies to respond only to aggressive mode.

anymode Specifies to respond to any mode.

Default Values

By default, respond to any mode is enabled.

Applicable Platforms

This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900

Series units.

Command History

Release 4.1 Command was introduced.

Functional Notes

By using the initiate and respond commands, you can configure the IKE policy to initiate and respond,

initiate only, or respond only. It is an error if you have both initiate and respond disabled.

Usage Examples

The following example configures the router to initiate and respond to IKE negotiations:

(config-ike)#respond anymode

(config-ike)#initiate main