ADTRAN 1000R Series attribute <policynumber>

Command Reference Guide IKE Policy Command Set

attribute <policynumber>

Use the attribute command to define attributes for the associated IKE policy. Multiple attributes can be

created for a single IKE policy. Once you enter this command, you are in the IKE Policy Attribute mode.

Refer to IKE Policy Attributes Command Set on page 1254 for more information.

Syntax Description

<policynumber> Assigns a number (range: 1 to 65,535) to the attribute policy. The number is the

attribute's priority number and specifies the order in which the resulting VPN

proposals get sent to the far end.

This command takes you to the (config-ike-attribute)# prompt. From here, you

can configure the settings for the attribute as outlined in the section IKE Policy

Attributes Command Set on page 1254.

Default Values

By default, no attribute is defined.

Applicable Platforms

This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900

Series units.

Command History

Release 4.1 Command was introduced.

Functional Notes

Multiple attributes on an IKE policy are ordered by number (with the lowest number representing the

highest priority).

Usage Examples

The following example defines a policy attribute (10) and takes you into the IKE Policy Attributes:

(config-ike)#attribute 10

(config-ike-attribute)#