ADTRAN 1000R Series ip sntp source-interface <interface>

Command Reference Guide Global Configuration Mode Command Set

ip sntp source-interface <interface>

The ip sntp source-interface command to use the specified interface’s IP address as the source IP address

for SNTP traffic transmitted by the unit. Use the no form of this command if you do not wish to override

the normal source IP address.

Syntax Description

<interface> Specifies the interface to be used as the source IP address for SNTP traf fic.Type

ip sntp source-interface? for a complete list of valid interfaces.

Default Values

No default value is necessary for this command.

Applicable Platforms

This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and

Total Access 900 Ser ies units.

Command History

Release 6.1 Command was introduced.

Functional Notes

This command allows you to overr ide the sender field in the IP packet. If you have multiple interfaces in

your unit, changing the sender tells the receiver where to send replies. This functionality can also be used

to allow packets to get through firewalls that would normally block the flow.

Usage Examples

The following example configures the unit to use the loopback 1 interface as the source IP for SNTP

traffic:

(config)#ip sntp source-interface loopback