Command Reference Guide Modem Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 671

MODEM INTERFACE CONFIGURATION COMMAND SET

To activate the Modem Interface Configuration mode, enter the interface modem command at the Global
Configuration mode prompt. For example:
>enable
#
configure terminal
(config)#
interface modem 1/2
(config-modem 1/2)#
The following comm a nd s are com mo n to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
caller-id override [always <number> | if-no-cid <number>] on page 672
dialin on page 673
init-string <string> on page 674
resource pool-member <pool-name> [<cost>] on page 675
The modem interface number in the example above is shown as modem 1/2. This number is
based on the interface’s location (slot/port) and could vary depending on the u nit’s
configuration. Use the do show interfaces command to determine the appropriate
interface number.