Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 194
show interfaces <interface>
Use the show interfaces command to display configuration parameters and current statistics for all
interfaces (or a specified interface).
Syntax Description
<interface> Optional. S pecifies the interface to d isplay . T ype show interfaces ?
for a complete list of valid interfaces.
description Optional. Displays infor mation such as name, administra tive status,
protocol, and description for all the interfaces.
performance-statistics Optional. Displays the current 15-minute interval, the current
24-hour totals, and all 96 stored intervals.
performance-statistics total-24-hour Optional. Displays the current 24-hour totals an d the past seven
24-hour intervals.
performance-statistics <x-y> Shows the current 15-minute interval, the current 24-hour totals,
and all intervals from x through y. This command is basically the
same thing as the performance-statistics command with the
added functio n of allo win g yo u to specify a particular interval (or
range of intervals) to display rather than displaying all 96.
realtime Displays full-screen output in real time. See the Functional Notes
below for more information.
status Optional. Displays information such as name, type, status, VLAN,
speed, and duplex for all the Ethernet interfaces only.
verbose Displays detailed configuration information on the terminal screen
(versus only the non-default values).
version Optional. Displays current version information (e.g., model an d list
number, software version, etc.) for the T1 interface.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Note: If you want to display the 24th interval, enter (for example) show interface t11/1
performance-statistics 24-24. Entering show interface t1 1/1 performance-statistics 24
results in displaying the 24-hour statistics. Any number other than 24 (between 1 and 96)
results in the correct display of the selected interval (e.g., show interface t1 1/1
performance-statistics 4 shows the fourth interval).