ADTRAN 1000R Series access-list <listname> [in | out]

Command Reference Guide BGP Neighbor Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1283
access-list <listname> [in | out]
Use the access-list command to assign a predefined access list to a BGP neighbor. This list is then used to
filter inbound and/or outbound BGP route updates. Use the no form of this command to return to default
settings.
Syntax Description
<listname> Assigns an access list to this BGP neighbor.
in Specifies the filtering of all inbound BGP route updates.
out Specifies the filtering of all outbound BGP route updates.
Default Values
By default, no access lists are specified for filtering.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 9.3 Command was introduced.
Functional Notes
Before they can be assigned to a neighbor, access lists must first be defined using the ip access-list
commands. See ip access-list extended <listname> on page 392 and ip access-list standard <listname>
[permit | deny] <ip address> on page 398 for more information.
Usage Examples
The following example uses the InWeb access list to filter all inbound BGP route updates:
(config)#router bgp-neighbor 192.22.73.101
(config-bgp-neighbor)#access-list InWeb in