Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 301
Usage Examples
The following example displays the configuration of the switch stack while in stack-master mode:
>enable
#show stack
Stack mode is MASTER
Management Vlan is 2386, firmware version is 08.00.18 .D
Stack network is 169.254.0.0/24
Stack members...
Member stack member's Unit ID
MAC address stack member's MAC address
Mgmt IP Address stack member's IP address
Source Interface interface that the stack member was learned from
State Up (member is up and functioning properly); Down (member was at one time
functioning, but we have lost contact with it); Waiting (we are waiting for the unit
to register with us; when he does, we will add it to the stack); Denied (the unit
could not be added to the stack because the stack protocol versions were not
compatible).
The following example displays the configuration of the switch stack while in stack-member mode:
>enable
#show stack
Stack mode is STACK-MEMBER
My Unit ID is 3, management Vlan is 2386
Stack management network is 169.254.0.0/24
Stack Master info:
Master is "Switch", learned via giga-eth 0/1
IP address is 169.254.0.1, MAC address is 00:DE:AD:00:65:83
#
The following example displays all units that have registered with this stack-master.
Member Mac Address Mgmt IP Address Source Interface State
2 00:A0:C8:02:CF:C0 169.254.0.2 Stack port Up
3 00:A0:C8:00:8C:20 169.254.0.3 Stack port Up
#