ADTRAN 1000R Series

Command Reference Guide Frame Relay Sub-Interface Config Command Set

ip ospf

Use the ip ospf command to customize OSPF settings (if needed).

Default Values

retransmit-interval <seconds> 5 seconds

transmit-delay <seconds> 1 second

hello-interval <seconds> 10 seconds: Ethernet, point-to-point, Frame Relay, and PPP

dead-interval <seconds> 40 seconds

Applicable Platforms

This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.

Command History

Release 3.1 Command was introduced.

Syntax Description

authentication-key

<password> Assigns a simple-text authe n ticatio n password to be used by other routers

using the OSPF simple password authentication.

cost <value> Specifies he OSPF cost of sending a packet on the interface. This value

overrides any computed cost value. Range: 1 to 65,535.

dead-interval

<seconds> Sets the maximum interval allowed between hello packets. If the maximum

is exceeded, neighboring devices will determine that the device is down.

Range: 0 to 32,767.

hello-interval

<seconds> Specifies the interval between hello p acket s sent on the inter face. Range: 0

to 32,767.

message-digest-key

<keyid> md5 <key> Configures OSPF Message Digest 5 (MD5) authentication (16-byte

maximum) keys.

priority

<value> Sets the OSPF priority. The value set in this field helps determine the

designated router for this network. Range: 0-255.

retransmit-interval

<seconds> Specifies the time between link-state advertisements (LSAs). Range: 0 to

32,767.

transmit-delay

<seconds> Set s the estim ated time required to se nd an LSA on the interface. Range : 0

to 32,767.