ADTRAN 1000R Series clear ip policy-sessions

Command Reference Guide Enable Mode Command Set

clear ip policy-sessions

clear ip policy-sessions

clear ip policy-sessions <classname> [ahp | esp | gre | icmp | tcp | udp | <protocol>] <source ip>

clear ip policy-sessions <classname> [ahp | esp | gre | icmp | tcp | udp | <protocol>] <source ip>

<source port><dest ip><dest port> [destination | source] <nat ip><nat port>

Syntax Description

<classname> Alphanumeric descriptor for identifying the configured access policy (access

policy descriptors are not case-sensitive).

ahp Specifies authentication header protocol (AHP).

esp Specifies encapsulating security payload protocol (ESP).

gre Specifies general routing encapsulation protocol (GRE).

icmp Specifies Internet control message protocol (ICMP) protocol.

tcp Specifies transmission control protocol (TCP).

udp Specifies universal datagram protocol (UDP).

<protocol> Specifies protocol (valid range: 0 to 255).

<source ip> Specifies the source IP address (format is A.B.C.D).

<source port> Specifies the source port (in hex format AHP, ESP, and GRE; decimal for all other

protocols).

<dest ip> Specifies the destination IP address (format is A.B.C.D).

<dest port> Specifies the destination port (in hex format for AHP, ESP, and GRE; decimal for

all other protocols).

[destination | source] For NAT sessions, this specifies whether to select a NAT source or NAT

destination session.

<nat ip> For NAT sessions, this specifies the NAT IP address (format is A.B.C.D).

<nat port> For NAT sessions, this specifies the NAT port (in hex fo rmat for AHP, ESP, and

GRE; decimal for all other protocols).

Default Values

No default value necessary for this command.

Applicable Platforms

This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and

Total Access 900 Series units.