ADTRAN 1000R Series traceroute <address> source <address>

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 319
traceroute <address> source <address>
Use the traceroute command to display the IP routes a packet takes to reach the specified destination.
Syntax Description
<address> Optional. Specifies the IP address of the remote system to trace the routes to.
source <address> Optional. Specifies the IP address of the interface to use as the source of the trace.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Usage Examples
The following is a sample traceroute output:
>enable
#traceroute 192.168.0.1
Type CTRL+C to abort.
Tracing route to 192.168.0.1 over a maximum of 30 hops
1 22ms 20ms 20ms 192.168.0.65
2 23ms 20ms 20ms 192.168.0.1
#
The following example specifies the source of the trace. The ip address 10.10.10.10 is the destination
address:
>enable
#traceroute 10.10.10.10 source 192.168.0.3