ADTRAN 1000R Series copy tftp <destination>

Command Reference Guide Enable Mode Command Set

copy tftp <destination>

Use the copy tftp command to copy a file located on a network Trivial File Transfer Protocol (TFTP)

server to a specified destination.

Syntax Description

<destination> Specifies the destination of the file copied from the TFTP server.

Valid destinations include: flash (FLASH memory), startup-config (the

configuration file stored in NVRAM), or running-config (the current runnin g

configuration file).

After entering c opy tftp and specifying a destination, the AOS prompts for

the following information:

Address of remote host: IP address of the TFT P s erv er.

Source filename: Name of the file to copy from the TFTP server.

Destination filename: Specifies the filename to use when storing the copied file to FLASH

memory. (Valid only for the copy tftp flash command.)

Default Values

No default value necessary for this command.

Applicable Platforms

This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and

Total Access 900 Series units.

Command History

Release 1.1 Command was introduced.

Usage Examples

The following example copies myfile.biz from the TFTP server (10.200.2.4) to flash memory and labels it

newfile.biz:

>enable

#copy tftp flash

Address of remote host?10.200.2.4

Source filename myfile.biz

Destination filename newfile.biz

Initiating TFTP transfer...

Received 45647 bytes.

Transfer Complete!