ADTRAN 1000R Series port-auth auth-mode [mac-based | port-based]

Command Reference Guide Ethernet Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 630
port-auth auth-mode [mac-based | port-based]
Use the port-auth auth-mode command to configure the authentication mode. Use the no form of this
command to return to the default settings.
Syntax Description
mac-based Specifies a MAC-based authentication mode. Each host must authenticate
separately.
port-based Specifies a port- based authentication mode. Only a single host can participate in
the authentication process.
Default Values
By default, the authentication mode is port-based.
Applicable Platforms
This command applies to the NetVanta 1000 and 1000R Series units.
Command History
Release 10.1 Command was introdu ced.
Usage Examples
The following example configu res the unit for MAC-based authentication mode:
(config)#interface ethernet 0/1
(config-eth 0/1)#port-auth auth-mode mac- based