Command Reference Guide Global Configuration Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 456

line [console | telnet | ssh] <line-number> <ending number>

Use the line command to enter the line configuration for the specified console, Telnet, or secure shell
(SSH) session. Refer to the sections Line (Console) Interface Config Command Set on page 532, Line
(Telnet) Interface Config Command Set on page 553, and Line (SSH) Interface Config Command Set on
page 545 for information on the subcommands.
Syntax Description
console
Enters the configuration mode for the DB-9 (female)
CONSOLE
port located on the
rear panel of the unit.
Refer to the sections Line (Console) Interface Config
Command Set on page 816 for information on the subcommands found in that
command set.
telnet
Enters the configuration mode for Telnet session(s), allowing you to configure for
remote access.
Refer to the section Line (Telnet) Interface Config Command Set
on page 553 for information on the subcommands found in that command set.
ssh Enters the configuration mode for SSH. Refer to the section Line (SSH) Interface
Config Command Set on page 545 for information on the subcommands fo und in
that command set.
<line-number> Specifies the starting session to configure for remote access (valid range for
console: 0; valid range for Telnet and SSH: 0 to 4).
If configuring a single Telnet or SSH session, ente r the session number and leave
the <ending number> field blank.
<ending number>
Optional.
Specifies the last Telnet or SSH session to configure for remote access
(valid range: 0 to 4).
For example, to configure all available Telnet sessions, enter line telnet 0 4.
Default Values
By default, the AOS
line console parameters are configured as follows:
Data Rate: 9600
Da ta bits: 8
Stop bits: 1
Parity Bits: 0
No flow control
By default, there are no configured Telnet or SSH sessions.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.