ADTRAN 1000R Series snmp-server host <address> traps version <version> <community> <trap type> [snmp]

Command Reference Guide Global Configuration Mode Command Set

snmp-server host <address> traps version <version> <community>

Use the snmp-server host traps version command to specify traps sent to an identified host. Use multiple

snmp-server host traps version commands to specify all desired hosts. Use the no form of this command

to return to the default value.

Syntax Description

<address> Specifies the IP address of the SNMP host that receives the traps.

<version> Specifies the SNMP version as one of the following:

1 - SNMPv1

2C - SNMPv2C

<community> Specifies the community string (used as a password) for authorized agents to

obtain access to SNMP information.

<trap type> Specifies the type of notification trap to enable. Leaving this option blank enables

ALL system traps.

snmp Optional. Enables a subset of traps specified in RFC1157.

The following traps are supported:

coldStart

warmStart

linkUp

linkDown

authenticationFailure

Default Values

By default, there are no hosts or traps enabled.

Applicable Platforms

This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and

Total Access 900 Series units.

Command History

Release 1.1 Command was introduced.

Usage Examples

The following example sends all SNMP traps to the host at address 190.3.44.69 and community string My

Community using SNMPv2C:

(config)#snmp-server host 190.3.44.69 traps version 2c My Community snmp