ADTRAN 1000R Series - page 641

Command Reference Guide Ethernet Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 641
spanning-tree edgeport
Use the spanning-tree edgeport command to configure the interface to be an edgeport. This command
overrides the related Global setting (refer to span ning-tree edgeport default on page 518). Use the no
version of the command to return to the default setting.
Syntax Description
No subcommands.
Default Values
By default, this setting is disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1 Command was introduced.
Functional Notes
Enabling this command configures the interface to go to a forwarding state when the link becomes active.
When not enabled, an interface must go through the listening and learning states before going to the
forwarding state.
Usage Examples
The following example configu res the interface to be an edgeport:
(config)#interface eth 0/1
(config-eth 0/1)#spanning-tree edgeport
An individual interface can be configured to not be considered an edgeport. For example:
(config)#interface ethernet 0/1
(config-eth 0/1)#no spanning-tree edgeport