ADTRAN 1000R Series stack [master | member | vlan] <master> <member> <vlan>

Command Reference Guide Global Configuration Mode Command Set

stack [master | member | vlan] <master> <member> <vlan>

Use the stack command to configure switch-stacking options.

Syntax Description

master Specifies that the unit will be the master of the stack.

<vlan> Configures the private IP network the stack will use for communication.

<IP network> Configures the network mask of the private IP network.

<IP mask> Configures the VLAN over which the private IP network will operate. (2386 is the

default).

member Adds a switch to the stack.

<MAC address> Specifies the MAC address of the unit being added.

<unit id> Specifies the unit ID of the switch being added.

vlan

Specifies the

management VLAN of the stack of which you are a member.

vlan> Setting this value puts you in stack member mode, as opposed to stack master

mode.

Default Values

By default, stack vlan is 2386, and the stack IP network is 169.254.0.0/24.

Applicable Platforms

This command applies to the NetVanta 1000 and 1000R Series units.

Command History

Release 8.1 Command was introduced.

Usage Examples

The following are variations of the stack command:

This example configures the unit to be the stack master and use the default stack VLAN and IP network.

(config)#stack master 2000

This example configures the unit to be the stack master and use VLAN 2000 as the management VLAN

and 192.168.1.0/24 as the management network.

(config)#stack master 2000 192.168.1.0 255.255.255.0