ADTRAN 1000R Series network <address> <subnet mask>

Command Reference Guide Router (RIP) Configuration Command Set

network <address> <subnet mask>

Use the network command to enable RIP on the specified network. The AOS will only allow processing

(sending and receiving) RIP messages on interfaces with IP addresses that are contained in the networks

listed using this command. All RIP messages received on interfaces not listed using this command will be

discarded. To allow for receiving and participating in RIP but not for transmitting, use the

passive-interface command (refer to passive-interface <interface> on page 1320). Use the no form of this

command to remove a network from the list.

Syntax Description

<address> Specifies the IP address of the network on which RIP will be enabled.

<subnet mask> Specifies the subnet mask that corresponds to the entered IP address.

Default Values

By default, RIP is not enabled.

Applicable Platforms

This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900

Series units.

Command History

Release 1.1 Command was introduced.

Usage Examples

The following example enables RIP on the 102.22.72.252/30, 192.45.2.0/24, and 10.200.0.0/16 networks:

(config)#router rip

(config-rip)#network 102.22.72.252 255.255.255.252

(config-rip)#network 192.45.2.0 255.255.255.0

(config-rip)#network 10.200.0.0 255.255.0.0