ADTRAN 1000R Series frame-relay interface-dlci <dlci>

Command Reference Guide Frame Relay Sub-Interface Config Command Set

frame-relay interface-dlci <dlci>

Use the frame-relay interface-dlci command to configure the Data Link Connection Identifier (DLCI) for

the Frame Relay sub-interface. This setting should match the DLCI supplied by your Frame Relay service

provider. Use the no form of this command to remove the configured DLCI.

Syntax Description

<dlci> Specifies numeric value supplied by your provider.

Default Values

By default, the DLCI is populated with the sub-interface identifier. For example, if configuring the virtual

Frame Relay sub- interface labeled fr 1.20, the default DLCI is 20.

Applicable Platforms

This command applies to the NetVanta 1000R, 3000, 4000, and 500 0 and Total Access 900 Series units.

Command History

Release 1.1 Command was introduced.

Usage Examples

The following example configures a DLCI of 72 for this Frame Relay endpoint:

(config)#interface frame-relay 1.16

(config-fr 1.16)#frame-relay interface-dlci 72