ADTRAN 1000R Series crypto ike

Command Reference Guide Global Configuration Mode Command Set

crypto ike

Use the crypto ike command to define the system-level local ID for IKE negotiations and to enter the IKE

Client or IKE Policy command sets.

Variations of this command include the following:

crypto ike client configuration pool <poolname>

crypto ike local-id address

crypto ike policy <policy priority>

Syntax Description

client configuration pool

Creates a local pool named the

of your choice and

enters the IKE Client. Clients that connect via an IKE policy that

specifies this pool-name will be assigned values from this pool.

Refer to the section IKE Client Command Set on page 1250 for

more information.

local-id address Sets the local ID during IKE negotiation to be the IP address of

the interface from which the traffic exits. This setting can be

overridden on a per-policy basis using the local-id command in

the IKE Policy (refer to local-id [address | asn1-dn | fqdn |

user-fqdn] <ipaddress or name> on page 1267 for more

information).

policy

Creates an IKE policy with the

of your choice and

enters the IKE Policy. Refer to IKE Policy Command Set on page

1260 for more information.

Default Values

There are no default settings for this command.

Applicable Platforms

This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900

Series units.

Command History

Release 4.1 Command was introduced.

Usage Examples

The following example creates an IKE policy with a policy priority settin g of 1 and en te rs the IKE Policy for

that policy:

(config)#crypto ike policy 1