ADTRAN 1000R Series ENABLE MODE COMMAND SET

Command Reference Guide Enable Mode Command Set

ENABLE MODE COMMAND SET

To activate the Enable mode, enter the enable command at the Basic mode prompt. (If an enable password

has been configured, a password prompt will display.) For example:

>enable

Password: XXXXXXX

The following command is common to multiple command sets and is covered in a centralized section of

this guide. For more information, refer to the section listed below:

exit on page 34

All other commands for this command set are described in this section in alphabetical order.

clear commands begin on page 38

clock auto-correct-dst on page 80

clock no-auto-correct-dst on page 81

clock set <time> <day> <month> <year> on page 82

clock timezone <text> on page 83

configure [memory | network | overwrite-network | terminal] on page 86

copy <source> <destination> on page 87

copy console <filename> on page 88

copy flash <destination> on page 89

copy <filename> interface <interface> <slot/port> on page 90

copy tftp <destination> on page 91

copy xmodem <destination> on page 92

debug commands begin on page 93

dir on page 146

dir [<input> | flash | flash <input>] on page 147

disable on page 148

enable on page 149

erase [<filename> | startup-config] on page 150

events on page 151

exception report generate on page 152

logout on page 153

ping <address> on page 154

ping stack-member on page 156

reload [cancel | in <delay>] on page 157