ADTRAN 1000R Series - page 715

Command Reference Guide ATM Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 715
snmp trap
Use the snmp trap command to enable all supported Simple Network Management Protocol (SNMP)
traps on the interface.
Syntax Description
No subcommands.
Default Values
By default, all interfaces (except virtual Frame Relay interfaces and sub-interfaces) have SNMP traps
enabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, and 4000 Series units.
Command History
Release 1.1 Command was introduced.
Release 3.1 Command was extended to the SHDSL interface .
Release 5.1 Command was expanded to includ e Ethernet su b-interfac es and Gigabit Ethe rnet
interfaces.
Release 8.1 Command was expanded to include ATM interfaces.
Usage Examples
The following example enables SNMP on the ATM interface:
(config)#interface atm 1
(config-atm 1)#snmp tra p