ADTRAN 1000R Series set transform-set <setname1

Command Reference Guide Crypto Map IKE Command Set

set transform-set <setname1 - setname6>

Use the set transform-set command to assign up to six transform sets to a crypto map. Refer to crypto

ipsec transform-set <setname> <parameters> on page 374 for information on defining transform sets.

Syntax Description

<setname> Assign up to six transform sets to this crypto map by listing the set names,

separated by a space.

Default Values

By default, there is no transform set assigned to the crypto map.

Applicable Platforms

This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900

Series units.

Command History

Release 4.1 Command was introduced.

Functional Notes

Crypto map entries do not directly contain the transform configuration for securing data. Instead, the crypto

map is associated w ith tr an sfo rm sets which contain specific security algorith ms (see

(see

crypto ipsec

transform-set <setname> <parameters> on page 374).

If no transform set is configured for a crypto map, then the entry is incomplete and will have no effect on

the system.

Usage Examples

The following example first create s a transform set (Set1) consisting of two security a lgorithms (up to three

may be defined), and then assigns the transform set to a crypto map (Map1):

(config)#crypto ipsec transform-set Set1 esp-3des esp-sha-hmac

(cfg-crypto-trans)#exit

(config)#crypto map Map1 1 ipsec-ike

(config-crypto-map)#set transform-set Set1