ADTRAN 1000R Series channel-group <group#> mode on

Command Reference Guide Ethernet Interface Configuration Command Set

channel-group <group#> mode on

Use the channel-group mode on command to add the interface to a channel-group. To remove an

interface from a channel-group, use the no version of this command.

Syntax Description

<group#> Specifies the channel-group number (1 to 6).

mode on Statically adds the interface to a channel group.

Default Values

By default, the interface is not part of a channel group.

Applicable Platforms

This command applies to the NetVanta 300, 1000, and 1000R Series units.

Command History

Release 5.1 Command was introduced.

Functional Notes

There can be up to six channel groups with 2-8 interfaces per group. Dynamic protocols are not yet

supported (only static). A physical interface can be a memb er of only one channel group.

Usage Examples

The following exam ple ad ds the Eth er ne t 0/ 1 inte rf ac e to chan n el gr ou p 1:

(config)#interface eth 0/1

(config-eth 0/1)#channel-group 1 mode on

(config-eth 0/1)#