ADTRAN 1000R Series frame-relay lmi-type [ansi | auto | cisco | none

Command Reference Guide Frame Relay Interface Config Command Set

frame-relay lmi-type [ansi | auto | cisco | none | q933a]

Use the frame-relay lmi-type command to de fine the Frame Relay signal ing (LMI) type. Use the no form

of the command to return to the default value.

Syntax Description

ansi Specifies Annex D signaling method.

auto Automatically determines signaling type by messages received on the frame

circuit.

cisco Specifies Group of 4 signaling method.

none Turns o ff signaling on the endpoint. This is used for dial-backup connections to

ADTRAN IQ and Express series products.

q933a Specifies Annex A signaling method.

Default Values

By default, the Frame Relay signaling type is set to ansi.

Applicable Platforms

This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.

Command History

Release 1.1 Command was introduced.

Release 2.1 Added signaling type none to provide support for dia l -b acku p to ADTRAN IQ and

Express series products.

Usage Examples

The following example sets the signaling method for the endpoint to cisco:

(config)#interface frame-relay 1

(config-fr 1)#frame-relay lmi-type cisco