ADTRAN 1000R Series show arp [realtime]

Command Reference Guide Enable Mode Command Set

show arp [realtime]

Use the show arp command to display the Address Resolution Protocol (ARP) table.

Syntax Description

realtime Displays full-screen output in real time. See the Functional Notes below for more

information.

Default Values

No default value necessary for this command.

Applicable Platforms

This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and

Total Access 900 Series units.

Command History

Release 1.1 Command was introduced.

Release 10.1 The real time display option was introduced.

Functional Notes

Use the realtime argument for this command to display full-screen output in real time. Information is

continuously update d on the console until you either freeze the data (by pressing the F key) or exit

realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the

information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,

increase the terminal leng th (usin g the terminal length command; refer to terminal length <text> on page

318).

Usage Examples

The following is a sample output of the show arp command:

>enable

#show arp

ADDRESS TTL (min) MAC ADDRESS LAST UPDATED (min) INTERFACE

192.168.30.36

192.168.30.253

224.0.0.9

71578541

00:E0:7D:88:1A:B9

02:60:8C:DD:0A:CE

01:00:5E:00:00:09

4260

4264

eth 0/1

eth 0/2