ADTRAN 1000R Series set peer <address>

Command Reference Guide Crypto Map IKE Command Set

set peer <address>

Use the set peer command to set the IP address of the peer device. This must be set for multiple remote

peers.

Syntax Description

<address> Specifies the IP address of the peer device. If this is not configured, it implies

responder only to any peer.

Default Values

There are no default settings for this command.

Applicable Platforms

This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900

Series units.

Command History

Release 4.1 Command was introduced.

Functional Notes

If no peer IP addresses are configured, the entry will only be used to respond to IPSec requests; it cannot

initiate the requests (since it doesn't know wh ich IP ad dr es s to send the packet to). If a single peer IP

address is configured, the crypto map entry can be used to both initiate and respond to SAs.

The peer IP address is the public IP address of the device which will terminate the IPSec tunnel. If the peer

IP address is not static, the ADTRAN product cannot initiate the VPN tunnel. By setting no peer IP

address, the ADTRAN product can respond to an IPSec tunnel request.

Usage Examples

The following example sets the peer IP address o f 10.100.23.64:

(config-crypto-map)#set peer 10.100.23.64