ADTRAN 1000R Series

Command Reference Guide Serial Interface Configuration Command Set

snmp trap link-status

Use the snmp trap link-status command to control the Simple Network Management Protocol (SNMP)

variable ifLinkUpDownTrapEnable (RFC2863) to enable (or disable) the interface to send SNMP traps

when there is an interface status change. Use the no form of this command to disable this trap.

Syntax Description

No subcommands.

Default Values

By default, the ifLinkUpDownTrapEnable OID is enabled for all interfaces except virtual Frame Relay

interfaces.

Applicable Platforms

This command applies to the NetVanta 1000R, 3000, and 4000 Series and Total Access 900 Seri es units.

Command History

Release 1.1 Command was introduced.

Release 3.1 Command was extended to the SHDSL interface .

Release 5.1 Command was expanded to include Gigabit Ethernet, port channel, VLAN, E1,

and G.703 interfaces.

Functional Notes

The snmp trap link-st atus command is used to control the RFC 2863 ifLinkUpDownT rapEnable OID (OID

number 1.3.6.1.2.1.31.1.1.1.14.0).

Usage Examples

The following example disables the link-status trap on the serial interface:

(config)#interface serial 1/1

(config-ser 1/1)#no snmp trap link-status