ADTRAN 1000R Series signaling-mode [message-oriented | none

Command Reference Guide DSX-1 Interface Configuration Command Set

signaling-mode [message-oriented | none | robbed-bit]

Use the signaling-mode command to configure the signaling type (robbed-bit for voice or clear channel

for data) for the DS0s mapped to the DSX-1 port.

Syntax Description

message-oriented Specifies clear ch annel signa ling on Chann el 24 o nly. Use this signaling type with

QSIG installations.

none Specifies clear channel signaling on all 24 DS0s. Use this signaling type with

data-only or PRI DSX-1 installations.

robbed-bit Specifies robbed bit signaling on all DS0s. Use this signaling type for voice-only

DSX-1 applications.

Default Values

By default, the signaling mode is set to robbed-bit.

Applicable Platforms

This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.

Command History

Release 1.1 Command was introduced.

Usage Examples

The following example configures the DSX-1 port for PRI compatibility:

(config)#interface t1 1/2

(config-t1 1/2)#signaling-mode none