ADTRAN 1000R Series snmp-server source-interface <interface>

Command Reference Guide Global Configuration Mode Command Set

snmp-server source-interface <interface>

Use the snmp-server source-interface command to tell the AOS the interface type from which to expect

the SNMP traps to originate. All SNMP originated packets (including traps and get/set requests) will use

the designated interface’s IP address. Use the no form of this command to remove specified interfaces.

Syntax Description

<interface> Specifies the physical interface that should originate SNMP traps. Enter

snmp-server trap-source ? for a complete list of valid interfaces.

Default Values

By default, there are no trap- source interfaces defined.

Applicable Platforms

This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and

Total Access 900 Series units.

Command History

Release 7.1 Command was introduced.

Usage Examples

The following example specifies that the Ethernet interface (ethernet 0/1) should be the source for all

SNMP traps and get/set requests:

(config)#snmp-server source-interface ethern et 0/1